Mig 120 Manual Exclusive - Cem Dual

Set your Voltage switch according to material thickness (e.g., Min-1 for 1mm sheet metal). Set your Wire Speed to a mid-point setting (around 4 or 5).

Operating the machine successfully requires a clear understanding of the front panel interfaces. While layout configurations vary slightly across production years, the primary controls remain identical.

What (steel, stainless, aluminum) are you trying to weld? cem dual mig 120 manual

Your includes a maintenance log. Here is the condensed version:

Torch must be Negative (-) , Earth/Ground Clamp must be Positive (+) . Note: Check inside the wire spool compartment for the terminal blocks or flying leads to swap these connections. Wire: Flux-cored wire (0.8mm E71T-GS). Set your Voltage switch according to material thickness (e

Because these are "old school" transformer machines, they are heavy and durable. Unlike modern inverter welders that are packed with digital menus, the Dual MIG 120 relies on simple, robust controls. However, without the manual, deciphering the voltage taps and wire feed settings can be a game of trial and error.

If you have lost your physical copy, do not use a third-party sketchy site. Here are legitimate sources: Here is the condensed version: Torch must be

By using the CEM Dual MIG 120, you acknowledge that you have read and understood the instructions and safety precautions outlined in this manual.