Keep the chiller running continuously, even when the laser is idle.
Water is too cold. Occurs in winter or if the heater fails. Allow it to self-warm. Room temperature sensor failure
The is a dual-circuit industrial water chiller specifically designed for cooling 6000W fiber laser systems. It features a "dual-effect" design that simultaneously cools both the fiber laser source and the optics (laser head) using two independent temperature control systems. Key Features : Temperature Stability : Typically cwfl-6000 manual
Connects to the fiber laser source.
| Issue | Possible Cause | Recommended Solution | | :--- | :--- | :--- | | Unit won't power on | Faulty power connection or blown fuse | Check power cord and outlet. Open the electrical box and inspect/replace the fuse if needed. | | or E07 over-temp alarm | High ambient temp, dirty condenser, or low water flow | Clean the air filter, check for proper ventilation, and verify water level is adequate. | | E01 or E02 flow alarm | Low water level, kinked hose, or air in the system | Top up water, straighten hose, and run the pump to purge air. | | Severe condensation | Water temp too low for ambient conditions | Adjust to a higher temperature setting or insulate the pipes. | | Poor cooling performance | Incorrect parameter settings | Reset parameters to factory defaults to eliminate incorrect user settings. | Keep the chiller running continuously, even when the
Technical tone should be precise but accessible: concise imperative steps for procedures, while reserving explanatory text for conceptual sections.
Pour water slowly until the indicator needle reaches the (Normal level). Allow it to self-warm
If the workshop drops below 0°C in winter, add specialized laser anti-freeze (e.g., ethylene glycol). 6. Troubleshooting and Alarm Codes
Use the and Down arrows to navigate to the desired temperature setting.