is intended for lead-acid batteries only, not non-rechargeable batteries. 2. Technical Specifications 12V (Nominal)
Flip the power switch to the position. The central red LED indicator will illuminate to signal that active charging power is flowing. Phase 3: Monitoring and Disconnection
If the charger has a charge indicator, it will show the status moving from low to full. bosch kl 1208 battery charger manual
Coil the cables loosely. Tightly wrapping cords around the plastic housing can break the copper strands inside the insulation over time.
Remove the battery from the vehicle if possible. If charging inside the vehicle, turn off all electrical components (lights, radio, ignition). The central red LED indicator will illuminate to
The KL 1208 does not have a separate "trickle charge" or "maintenance" mode. Leaving a battery on the charger for more than 2 hours after the light goes out is not recommended, as it can cause NiCd cell damage due to overcharging.
: For standard "wet" batteries, check that the fluid level covers the lead plates by at least 5mm before charging; top up with distilled water if needed. Temperature : Avoid using the charger in environments hotter than 35°C (95°F) or in moist rooms. electronic power systems pty. ltd. Tightly wrapping cords around the plastic housing can
Internal components are working under heavy load. This is normal for the first hour of a deeply discharged battery.
Connect the to the positive terminal of the battery.
Remove the battery cell caps (if applicable) to allow gases to vent. Check the electrolyte level in each cell. Top up with distilled water if levels are low. Step 2: Connection Order Ensure the charger is unplugged from the AC mains outlet.